For plastic flooring, everyone is familiar with it. It is one of the most common flooring products for our home improvement. It is not only very beautiful, good care, but also simple construction, can save time and effort, then, the plastic floor How to build a good? Here we come to a detailed introduction: floor plastic construction technology and floor plastic construction should pay attention to which four points? Hope to give you some help and inspiration.
Floor plastic construction process one:
In operation, it is necessary to measure the space size first, and cut the floor according to the size. Note that the cutting width should be slightly larger than the required width so that it can be overlapped and trimmed later.
Floor plastic construction technology II:
The sheared floor should be placed for 24 hours first, so that the curled part of the sheet can be fully developed and ready for post-laying.
Floor plastic construction process three:
Before the operation, remove the dust and stains on the ground, and then flatten the raised areas, level the hollows with 1:2 of 107 glue and cement, and wait until it is dry before leveling with sandpaper. After the ground is leveled, it can be glued.
Floor plastic construction process four:
Before the operation, it must be glued on the ground, painted one by one, and carried out in order. In the seam of the leather, 10 cm in width should be reserved and not glued in order to avoid later joint processing.
Floor plastic construction process five:
During construction, the diagonal lines should be aligned. After completion, the gas should be compacted and driven away from the inside with a long handle. The floor seams are to be stitched using overlapping cutting methods, in which the overlap width is preferably about 5 centimeters, with a long steel ruler aligned with the center of the overlap, in the cutting with a knife, remove the edge, and then in the Apply glue to the seams, press the seams together with the pressure roller to compact them, and finally, clean the excess glue so as not to affect the appearance. 
Floor plastic construction process VI:
After completion, it is necessary to see if there is a bubble. If there is a bubble, use a syringe to suck out the air inside, and then compact it. Then use a laundry to remove the remaining glue marks. If it can not be removed, use alcohol to remove it. Complete it.
Plastic floor construction should pay attention to which four points:
1, in the construction, it is best to lay two different colors in the room, the pattern of the floor, in addition, the separation line to be outside the door frame, so that the door is symmetrical floor.
2. When paving, use an eraser to knock from the center and blow the air bubbles away.
3, after completion, 3 days can not move.
4. Cut the sheet 5 days in advance and reserve some materials so as not to shrink the sheet and affect the later construction.
The article concludes: The four-point related knowledge of flooring plastic construction technology and floor plastic construction should be introduced here. In fact, the construction of plastic flooring is very simple, as long as the above steps can be completed step by step, but during construction, certain Clean up the dust and stains on the floor so as not to affect the paving effect.
Single Handle Sink Kitchen Mixer Faucet
Kitchen Sink Taps is an economic Kitchen Faucet, Single handle operate and cold valve core design. Outlet pipe can be 360 ° rotation, bubbler outlet water more lively and comfortable. Kitchen sink mixer is suitable for all kinds of kitchen sinks, single hole deck mounted installation.And the use of high-quality spool, you can also customize your favorite color
Single Handle Sink Kitchen Mixer Faucet,Single Handle Sink Kitchen Mixer,Single Handle Sink Kitchen Faucet,Single Handle Sink Kitchen Mixer Taps
WENZHOU CHENKAI SANITARY WARE CO.,LTD , https://www.cnchenkai.com