Many netizens are worrying that the washbasin in the bathroom is a good one for buying a suit or a sink for oneself. Which kind of benefit is more? Today Xiao Bian took everyone to see how to use cement to build a washbasin cabinet.
Because it is a cast-in-place basin, it must be reinforced and reinforced. This is similar to the use of reinforced concrete in a building, which can make the building more firm. There are also cement boards on the market, but the quality is quite different. As in some Mediterranean styles, the building of TV cabinets, etc., often involves the step of placing reinforcements. The workers here are reinforcing steel bars in a good measure.
Then the loft was laid out, the bricks were put out of the basin mold, and the steel bar was pressed up, and a cement bag could be put underneath.
Pour the mixed bean mortar into the mold you just made and level it with a shovel. This process must be completed and there must be no empty drums inside. Shake the cement bag and make the mortar more uniform.
Formal basins were erected, and all hanging places had angled steel supports.
Has begun to take shape.
Open the hole in the cement board according to the size of the wash basin, one side is the angle steel brushed with anti-rust paint, it is specially prepared for the tap. Since the slab is nearly 5cm thick and the tiles are at least 2cm thick, the sum is much larger than the length of the thread of a common faucet. The thickness of the angle steel is 0.6cm, and the tile is 2cm, a total of 2.6cm, so that the screw mouth is sufficient However, the angle steel should be wide enough to allow the entire hand to enter the fixed thread.
Then tile the tile, which is similar to the wall tile, in the corner of the place can be inverted 45 degrees, this is more beautiful. Paving can be pre-paved before, and the faucet should be left on the countertop.
You have done your job. After the faucet has been installed, the entire washbasin is ready.
>>> Links: The whole process of making cement cabinets and lessons learned
Construction Acceptance Tiles Three Trees Paint Cement Faucet Lacquer Cabinet Doors Bathroom Doors Size Bathroom Tiles Bathrooms Washbasins Bathroom Doors Bathroom Size
Globe Valves and angle valves are designed for throttling or regulating flow in commercial and industrial applications. Bronze, cast iron, or cast ductile iron materials. Threaded, flanged, or solder end connections.
Angle valves for use in commercial and industrial applications. Typical services include hot and cold water, HVAC, steam, compressed air, gas and other general utility services.
Vacuum angle valve is used for turn on or shut off the airflow in the vacuum pipeline, the applicable media is air and non-corrosive gases.
It has two structures, one is angle type and another is a 3-way type within an ISO-KF or ISO-F various flange end pre-pump port.
a) Small diameter (≤DN50) valve body are precision investment casting.
b) Large diameter (> DN50) valve body are molding shaped seamless steel or steel plate.
c) Bellows sealed structure can withstand 150ºCtemperature, metal sealed structure can withstand 450ºCtemperature.
d) Can install on any position to control the airflow in the vacuum pipeline, as an on-off valve purpose
Angle Valves, Angle Globe Valves, Brass Angle Valve, Zinc Angle Valve
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsir-valves.com