Wing gate installation step 1: pre-embedded lines
1. Set the position of the chassis according to the customer's requirements, choose a good route between the center of the fixed position of the chassis and the control room, and pre-bury or dig the cable trench.
2. Put the appropriate diameter cable pipe (PVC pipe or steel pipe) in the dug line trench, and insert the power cord and control wire required by the device (control wire includes: manual button wire 3 core, RS485 communication signal wire 3 core). If the distance is far, the power line and the control line must be separated from the tube (the distance between the two tubes should be more than 50CM).
3. Between the two gates, lay an 8-core connecting machine line connecting machine.
4. After all lines are laid, fill the concrete after successful commissioning.
Wing gate installation step two: fixed wing gate
1. First, power up the two wing gates to make the wing run to the closed state, and then align the wings of the two wing gates so that the wings are on the same line, and the distance between the wings is 3CM to 5CM
2. Need to test whether the infrared is aligned, and wait for all functions to be debugged
3. Make marks on the center of the screw hole center of the base and the edge of the chassis base on the ground, then remove the chassis, and drill holes vertically with a drill bit on the marked screw holes. The size and depth should meet the requirements of the expansion screw. To the original position, insert the expansion screw and tighten the screw
Sds Drill Bits
SDS Plus and SDS Max drill bits can be used for drilling operations in concrete, reinforced concrete, granite and similar materials. SDS-Plus has a drilling diameter of 4mm to 32mm and a drilling depth of 110mm to 1000mm; SDS-Max has a drilling diameter of 12mm to 52mm and a drilling depth of up to 1200mm.
SDS Drill Bits are available with two (properly shaped integral straight edges), three (star arrangement) or four (integral cross arrangement) inserts, made of cemented carbide. They are deeply embedded in the steel head with industrial solder and are characterized by a high degree of mechanical and heat resistance.
SDS Plus and SDS Max Bits should not only be selected based on the diameter of the drilled hole, but also their depth standard. Both of these measures are necessary to maximize productivity.
Sds Drill Bits,High Carbon Steel Drill Bits,Concrete Drill Bit,Flat Hammer Drill Bits
Danyang Yongshun Tools Co.,Ltd , https://www.ysdrillbitset.com