Six common problems and solutions for toilet installation
Zhong Tao Sanitary Ware
1. After the toilet is installed, do not rely on the wall?
This is related to the choice of the toilet drainage distance and the distance from the reserved sewage outlet pipe to the wall. The drainage distance of the toilet floor is generally 210mm, 305mm and 400mm. Under normal circumstances, the installation dimensions are 190-210mm, 285-305mm, and 380-400mm, which means that the back of the toilet is 20mm from the wall gap.
When purchasing, the user should select the size of the toilet according to the actual distance from the wall to the reserved sewage pipe in the home.
If the distance between the drain pipe and the wall has been fixed and is not standardized, an optional shifter can be used to adjust if there is no suitable drain to choose from. The shifter can generally increase or decrease the center maximum distance by about 100mm.
2, high back toilet straight back how to repair?
Due to the complexity of accessories and the high frequency of use, toilets are affected by water quality. In general, angle valves, hoses, and filters are needed to facilitate the routine maintenance of the toilet. Normally, the inlet angle valve is installed on the side of the toilet 200mm high above the wall.
For this type of high back toilet, the angle valve is installed on the back of the toilet and is blocked by the toilet after installation. In order to facilitate the maintenance, manufacturers usually have maintenance holes in the lower part of the toilet for these reasons.
During maintenance, the internal switch inlet angle valve can be accessed from the maintenance hole, or the cover of the tank can be opened from the upper part of the tank for maintenance, or the entire product can be removed for maintenance.
3, toilet drainage button, press it not play after the loose or loose?
This is related to the quality of the product. It cannot be played because the spring is not good in elasticity and it is loose because it is not locked. Buttons produced by general regular manufacturers will not have such conditions within the warranty period and the number of prescribed uses. However, some manufacturers have poorer production quality, and the number of uses and the shelf life will be relatively short.
4, wash the toilet surface yellow rust how to do?
Because of the water quality, after the product has been used for a long time, it will have yellow dirt on the surface. At this point, scrub with a detergent and then rinse with clean water.
5, which toilet with filter?
Due to the different working principle of the inlet valve of the toilet, some inlet valves with high water quality requirements should be equipped with a filter, and some manufacturers that do not require high water quality (such as float ball) will not be equipped with filters. network. US and Canada toilets are equipped with a filter, external or built-in inlet valve.
6, horizontal drainage toilet sewage outlet how to reserve?
The installation method of the horizontal drainage toilet is roughly the same as that of the lower drainage toilet. The difference is that the sewage drainage pipe reserved for the horizontal drainage toilet is on the wall. The height of the center of the drainage pipe is set to be 180mm and 100mm respectively, and the drainage pipe should be reserved when reserved. Exposing the wall about 100mm.
Construction acceptance Zhongyu toilet switch
Led Spot Light,Downlight Spot Light,Spot Light Aluminum,Store Spot Light
JIANGMEN MICHEN LIGHTING CO.,LTD , https://www.jmledbulb.com