1, daily care (except stains, vacuum); A. Fill the watering can with clean water and spray it on the stained area of ​​the carpet. Soak for about 3-5 minutes.
B. Cover the soil with a dry rag and squeeze it with your hand to suck out the moisture from the carpet. C. Spray a little carpet stain remover, wait a moment, brush with the hand brush, in order to avoid the proliferation of stains should be brushed from the surrounding to the middle;
D. Use a rag to remove the sewage, and then spray water again to dry; E. If you can't remove it, think of another way; F. Special stains, special treatment;
2, regular cleaning: (1) moderate cleaning (electron blistering) A. Inspect the carpet and remove dirt from the dirty area (such as oil stains, coffee stains, chewing gum, etc.), and scrape off the burned carpet hair from the smoke hole with a blade;
B. Fill the dry foam tank with clean water and dry foam carpet cleaner (the ratio depends on the detergent brand and carpet contamination level); C. Push the machine to the inner corner, install a carpet brush, and turn on the power;
D. Activate the electronic foaming box and wait for the foam to overflow from the edge of the carpet brush before starting boot cleaning. Swing the joystick and wash it from inside to outside according to the lateral overlapping route;
F. Afterwards, use the carpet wool comb to reverse comb the carpet wool so that the hair is erected. (Clean hair on the carpet, fruit, etc., carpet height) G. Open the window, put a hair dryer if necessary, and dry the carpet;
H. Clean, tidy up, check the machines and tools, put them back in the warehouse, and register them. I. After drying, clean the carpets with an upright vacuum cleaner; Recommended equipment: single-wipe BDS43/150&BDS43DUO C+ electronic bubble box, hair dryer, Upright vacuum cleaner
(2) Deep cleaning (pumping machine) A. Check the degree of contamination of the carpet to remove dirt from the dirty area (such as grease, coffee stains, chewing gum, etc.), scrape off the burned carpet hair with a blade;
B. Fill the clear water tank of the washing machine with clean water, and add appropriate amount of detergent to pour the appropriate amount of the foaming agent into the recovery tank. Push the machine up to 2-3m from the innermost corner, connect the hose power cord, and then start the machine for cleaning. Clean the line from the inner corner to the rear (to avoid omission);
D. During the cleaning process, the water level of the two tanks and the amount of foam in the recovery tank should be noticed at any time. If necessary, clean water and clearing agent should be added to the sewage. E. Afterwards, comb the carpet with a carpet wool comb (to clean the hair and debris on the carpet, the carpet is easy to dry);
F. Open the window and put in a hairdryer or bed linen; G. Organize, clean, inspect tools, thoroughly clean the machine, return it to the workplace and register;
H. After being dried, use a vertical vacuum cleaner to vacuum the carpet;
B. Cover the soil with a dry rag and squeeze it with your hand to suck out the moisture from the carpet. C. Spray a little carpet stain remover, wait a moment, brush with the hand brush, in order to avoid the proliferation of stains should be brushed from the surrounding to the middle;
D. Use a rag to remove the sewage, and then spray water again to dry; E. If you can't remove it, think of another way; F. Special stains, special treatment;
2, regular cleaning: (1) moderate cleaning (electron blistering) A. Inspect the carpet and remove dirt from the dirty area (such as oil stains, coffee stains, chewing gum, etc.), and scrape off the burned carpet hair from the smoke hole with a blade;
B. Fill the dry foam tank with clean water and dry foam carpet cleaner (the ratio depends on the detergent brand and carpet contamination level); C. Push the machine to the inner corner, install a carpet brush, and turn on the power;
D. Activate the electronic foaming box and wait for the foam to overflow from the edge of the carpet brush before starting boot cleaning. Swing the joystick and wash it from inside to outside according to the lateral overlapping route;
F. Afterwards, use the carpet wool comb to reverse comb the carpet wool so that the hair is erected. (Clean hair on the carpet, fruit, etc., carpet height) G. Open the window, put a hair dryer if necessary, and dry the carpet;
H. Clean, tidy up, check the machines and tools, put them back in the warehouse, and register them. I. After drying, clean the carpets with an upright vacuum cleaner; Recommended equipment: single-wipe BDS43/150&BDS43DUO C+ electronic bubble box, hair dryer, Upright vacuum cleaner
(2) Deep cleaning (pumping machine) A. Check the degree of contamination of the carpet to remove dirt from the dirty area (such as grease, coffee stains, chewing gum, etc.), scrape off the burned carpet hair with a blade;
B. Fill the clear water tank of the washing machine with clean water, and add appropriate amount of detergent to pour the appropriate amount of the foaming agent into the recovery tank. Push the machine up to 2-3m from the innermost corner, connect the hose power cord, and then start the machine for cleaning. Clean the line from the inner corner to the rear (to avoid omission);
D. During the cleaning process, the water level of the two tanks and the amount of foam in the recovery tank should be noticed at any time. If necessary, clean water and clearing agent should be added to the sewage. E. Afterwards, comb the carpet with a carpet wool comb (to clean the hair and debris on the carpet, the carpet is easy to dry);
F. Open the window and put in a hairdryer or bed linen; G. Organize, clean, inspect tools, thoroughly clean the machine, return it to the workplace and register;
H. After being dried, use a vertical vacuum cleaner to vacuum the carpet;
Plantation Shutter,Plantation Shutters,Plantation Shutters Cost,Plantation Shutters Lowes
Plantation Shutter, Window Blinds Co., Ltd. , http://www.nbshutter.com