With glass separation, the most important thing is to make the installation firm and not loose. Because the partition wall is easily collided, the safety of the partition wall should be considered first. The glass used for the partition wall should be made of safety glass. At present, the safety glass specified by our country is tempered glass and laminated glass.
Secondly, the thickness of the glass used for the partition wall should meet: toughened glass not less than 5mm, laminated glass not less than 6.38mm, and for frameless glass, tempered glass not less than 10mm thick should be used. In addition, the glass edge of the glass partition wall must not be in direct contact with the hard material. The gap between the edge of the glass and the bottom of the groove should not be less than 4 to 5 mm. The depth of the notch embedded in the wall, floor and top of the glass should be 5 to 6 mm. The depth is 8mm; when the thickness of the glass is 8 to 10mm, the depth is 10mm.
Before and after glass and slot gap: when the glass thickness is 5 ~ 6mm, before and after the gap is 2mm; glass thickness is 8 ~ 12mm, before and after the gap is 3mm, the gap using elastic sealant or rubber strip filling. The gap between the glass bottom and the bottom of the tank shall be no less than two pieces of PVC or rubber support blocks with Shore hardness of 80 to 90, and the length of the support block shall not be less than 10mm. Elastomeric positioning block liners with a length of not less than 25 mm are used on both sides of the glass and the bottom of the groove. The support block and the positioning block should be located at a position not less than 300 mm and 1/4 of the length from the groove.
For mirrors in bathrooms and other vulnerable areas, in addition to moisture-proof mirrors, other mirror glasses should be provided with moisture-proof isolation measures. The easiest way is to seal the mirror glass with a neutral sealant to prevent moisture from penetrating to damage the back of the mirror. Floor. Do not use acidic sealants because acidic sealants can erode the coating on the back of the mirror. For glass decorations that need to be connected to the power supply, care should also be taken to prevent leakage. For a general floor-to-ceiling glass partition wall provided for pure lighting, a crash mark shall be provided on the surface of the glass at a height of 1.5 to 1.7 m from the ground with a decorative pattern.
Glass decorated bathroom
Aluminium Tubes,High Quality Aluminium Tubes,Aluminium Tubes Details, Zhejiang Sunkey Industrial Co., Ltd.
SUZHOU RIZHONGTIAN ALUMINUM CO.,LTD. , http://www.alumi-china.com