With the advent of winter, the house decoration has entered a state of in full swing. Due to seasonal reasons, many items in the decoration have to draw attention to:
Everrest Memories Home Textiles
Matters needing attention: Determine whether the building wall is dry
The degree of dryness of the wall directly affects the construction quality of the later wall surface. If there is a problem with the presence of the wall, the back cover treatment should be performed as much as possible (after the original wall covering of the wall is removed, the interface agent for roller coating is used for back cover treatment). In addition, putty products with corresponding properties are used in the process of putting a putty, and latex paints with corresponding characteristics are used, and a latex paint primer is used.
Note two: determine whether the base putty is dry
During the construction of the wall surface, try to extend the time interval for scraping the putty. The reason for the climate in winter is that of deer and the drying speed is relatively slow. Therefore, try not to compress the schedule too tightly.
The water in putty cannot evaporate quickly when the heating is not connected. In this case, the first time the putty is not completely dry, the second time putty treatment is carried out, and the top coat of latex paint or wallpaper is applied. There will be a lot of hidden dangers - after the heating is turned on, rapid drying occurs, wall cracking or wall-to-wall edging will become inevitable!
In the case of warm ventilation should also pay attention to ventilation deer tripod, the case of closed windows, indoor humidity is not conducive to dry the wall, ventilation, try not to fully open the window, so that the temperature difference between indoor and outdoor will lead to dry enough!
Matters needing attention three: Reduce interior paint spraying construction
Due to the temperature in winter, the paint spraying process in the interior decoration is not conducive to paint evaporation. Focus on the real estate network, a large number of atomized paints will be adsorbed on the top surface of the wall or even the ground to form secondary pollution.
Matters needing attention four: Slurry construction work attention to antifreeze
Too low temperature will affect the cement condensation and prevent the cement mortar from freezing. If the room temperature is too low, add antifreeze as much as possible, and carry out effective and reasonable maintenance procedures.
Note 5: Avoid premature coverage
If the ground is floored with a wooden floor to deal with Sogou, then do not rush to lay the wooden floor after leveling on the ground. Prevent the floor from leveling the concrete floor without completely drying it and bring unnecessary moisture to the floor.
Matters needing attention 6: After the wood is fully dried
The wood keels used in the local ceilings, etc., are basically not completely dry, and the alumni of the fire-retardant coatings must be planed to be used in the construction. Therefore, it is necessary to look at the degree of drying to perform secondary drying. Do not rush to carry out the construction. After the air-drying is carried out, the deformation of the gypsum board is prevented from being deformed after the construction.
Matters needing attention seven: Wooden doors to prevent deformation cracking
After the Wooden Door is installed, as many as possible in the closed state instead of the long-term open state, open the door is free to take shape deer, close the state can be better to prevent it from deformation, the small deformation of the door can be closed orthotic.
At the intersection of the door and socket interface, the line of the door cover and the seam of the wall will change with the change of the indoor temperature. Therefore, it is crucial to choose the form of the angle of the door pocket. Do not choose the stitching of 45 degrees as far as possible, and use direct stitching, such as cracking. Do not rush to repair, wait until the end of spring warming after a better one-time repair.
Note VIII: Remember that the amount of overlap affects environmental protection
Excessive materials and furniture are used in limited spaces. Although a single product has already met the environmental standards, the increase in the amount of stacking used in a limited space will also cause environmental problems in the living environment. For example, wardrobes, wooden floors, wooden doors, bedside cabinets, dressing tables, TV cabinets, etc. are all superimposed in the bedroom at the same time, and they are closed for 10 hours. It is inevitable that they suffer from harmful substances. Therefore, ventilation should be done as much as possible before going to bed. At night, the bedroom door should be opened as much as possible.
Due to the seasonal nature of the winter decoration, the primary concern during construction and after construction at low temperatures is the quality of the construction.
Links: The purchase and maintenance of crystal lamps
Experience Talk Lacquer Door Lacquer Cement Heater Bedroom Door TV Wallpaper Door Bedroom Wardrobe Bedroom Bedroom Lamp Bedroom Door to Bedroom Door Bedroom Lamp
Shengyi Door Co., Ltd. , http://www.china-security-door.com