1. Before starting up, you must check whether the connection lines, plugs, sockets, power plugs and sockets of the CNC system and the host are correct.
2. It is very important to check the position of the upper and lower limit stop rings. It is necessary to maintain a certain distance between the two clamps to avoid mechanical damage caused by misoperation or loss of control of the main unit, especially sensors.
3. During the test, please do not press the key on the microcomputer control system.
4, according to the specific circumstances of the test to select the fixture, so as not to damage the fixture.
5. In the event of a sudden power failure, turn off all power immediately. After confirming that the power supply is stable, turn on the power in order. Frequent and frequent interruptions of the power supply can easily damage the microcomputer control system and the motor speed control system.
6. Do not leave the tester away from the machine while the host is running.
7. The value of the input tensile speed must be equal to the actual tensile speed of the testing machine, especially in tearing and peeling.
8. Do not do tensile test when the maximum fracture force of the specimen is not known, otherwise the sensor will be damaged due to sensor overload.
2. It is very important to check the position of the upper and lower limit stop rings. It is necessary to maintain a certain distance between the two clamps to avoid mechanical damage caused by misoperation or loss of control of the main unit, especially sensors.
3. During the test, please do not press the key on the microcomputer control system.
4, according to the specific circumstances of the test to select the fixture, so as not to damage the fixture.
5. In the event of a sudden power failure, turn off all power immediately. After confirming that the power supply is stable, turn on the power in order. Frequent and frequent interruptions of the power supply can easily damage the microcomputer control system and the motor speed control system.
6. Do not leave the tester away from the machine while the host is running.
7. The value of the input tensile speed must be equal to the actual tensile speed of the testing machine, especially in tearing and peeling.
8. Do not do tensile test when the maximum fracture force of the specimen is not known, otherwise the sensor will be damaged due to sensor overload.
Carbide Conical Button,Carbide Mining Button,Tapered Carbide Buttons,Tungsten Carbide Conical Button
Zhuzhou Kerui Cemented Carbide Co., Ltd. , https://www.carbide-china.com